Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1996NEW YORKER V6-3.5L VIN FREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - HVACCONTROL MODULE HVACSERVICE AND REPAIR
1996 Chrysler New Yorker V6-3.5L VIN F
Control Module HVAC: Service and Repair
1996 Chrysler New Yorker V6-3.5L VIN FSECTION Service and Repair
Blower Motor Resistor and Power Module Replacement
REMOVAL
1. Remove lower right under panel access cover silencer duct.
2. Disconnect wiring connector on blower motor module.
3. Remove blower motor module retaining screws.
4. Pull blower motor module out of heater housing.
INSTALLATION
For installation reverse the above procedures.
REMOVAL
1. Remove lower right under panel access cover silencer duct.
2. Disconnect wiring connector on blower motor module.
3. Remove blower motor module retaining screws.
Blower Motor Module:
4. Pull blower motor module out of heater housing.
INSTALLATION
For installation reverse the above procedures.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.