RKE Module Replacement

1996 Chrysler New Yorker V6-3.5L VIN FSECTION RKE Module Replacement
REMOTE KEYLESS ENTRY MODULE

REMOVAL

Remote Keyless Entry (RKE) Module:






1. Remove instrument panel top cover. The remote keyless entry module is mounted to the structural duct on the passenger side.

2. Remove the two screws attaching the receiver to the instrument panel structural duct.

3. Disconnect the two wiring connectors.

4. Replace module.

INSTALLATION

For installation, reverse the above procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.