Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Test 8A - No Response From Powertrain Control Module
WARNING: This page is about a different car, the 1998 Dodge Intrepid and 1998 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
. Perform VERIFICATION TEST VER-1
after each repair.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.