Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1996LHS V6-215 3.5L SOHCREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSMISSION CONTROL SYSTEMSDESCRIPTION AND OPERATIONREPROGRAMMED CONTROL MODULE INFORMATION
1996 Chrysler LHS V6-215 3.5L SOHC
Reprogrammed Control Module Information
1996 Chrysler LHS V6-215 3.5L SOHCSECTION Reprogrammed Control Module Information
This transmission control module (TCM) may have been reprogrammed to improve shift performance per TSB 18-24-95 (or a newer TSB).
If the TCM has been reprogrammed use Transmission Control Diagnostic Trouble Code Information and Test Procedures for model year 1996 -- or newer depending on TSB -- for this vehicle.
- e.g. If you had looked up a 1995 Caravan 3.0L then you would need to look up a 1996 Caravan 3.0L to access the applicable codes and charts.
The graphics, component locations, connector pinouts, and wire colors for the actual vehicle will still apply.
If the TCM has been reprogrammed use Transmission Control Diagnostic Trouble Code Information and Test Procedures for model year 1996 -- or newer depending on TSB -- for this vehicle.
- e.g. If you had looked up a 1995 Caravan 3.0L then you would need to look up a 1996 Caravan 3.0L to access the applicable codes and charts.
The graphics, component locations, connector pinouts, and wire colors for the actual vehicle will still apply.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.