Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Terminal/Connector Repair-Molex Connectors
1996 Chrysler LHS V6-215 3.5L SOHCSECTION Terminal/Connector Repair-Molex Connectors
1. Disconnect the battery.
2. Disconnect the connector from its mating half/component.
3. Insert the terminal releasing special tool 6742 into the terminal end of the connector.
4. Using special tool 6742, release the locking fingers on the terminal.
5. Pull on the wire to remove it from the connector.
6. Repair or replace the connector or terminal, as necessary.
2. Disconnect the connector from its mating half/component.
Molex Connector Repair:
3. Insert the terminal releasing special tool 6742 into the terminal end of the connector.
Using Special Tool 6742:
4. Using special tool 6742, release the locking fingers on the terminal.
5. Pull on the wire to remove it from the connector.
6. Repair or replace the connector or terminal, as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.