Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1995NEW YORKER V6-3.5L VIN FREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSMISSION CONTROL SYSTEMSDESCRIPTION AND OPERATIONTCM OUTPUTSELECTRONIC PINION FACTOR (98 ONLY)
1995 Chrysler New Yorker V6-3.5L VIN F
Electronic Pinion Factor (98 Only)
1995 Chrysler New Yorker V6-3.5L VIN FSECTION Electronic Pinion Factor (98 Only)
The nature of the Electronic Pinion Factor requires that certain features must be taken into consideration:
- If no pinion factor is stored in an installed TOM, the vehicle speedometer will not indicate speed when moving
- Selecting the wrong final drive ratio or tire size may cause the speedometer accuracy to fall out of specification
Use the following procedures to set the electronic pinion factor using the DRB Scan Tool:
- Select "Transmission" system, then "Miscellaneous" functions, then "Pinion Factor". The DRB will display the current tire size.
- If the tire size is incorrect, depress the Enter key and then select the correct size.
- Depress the Page Back key to exit the reset procedure.
NOTE: For 1997 MY and earlier the pinion factor was a fixed value and cannot be changed with the DRB.
- If no pinion factor is stored in an installed TOM, the vehicle speedometer will not indicate speed when moving
- Selecting the wrong final drive ratio or tire size may cause the speedometer accuracy to fall out of specification
Use the following procedures to set the electronic pinion factor using the DRB Scan Tool:
- Select "Transmission" system, then "Miscellaneous" functions, then "Pinion Factor". The DRB will display the current tire size.
- If the tire size is incorrect, depress the Enter key and then select the correct size.
- Depress the Page Back key to exit the reset procedure.
NOTE: For 1997 MY and earlier the pinion factor was a fixed value and cannot be changed with the DRB.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.