Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1995NEW YORKER V6-3.5L VIN FREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEDESCRIPTION AND OPERATIONMODES OF OPERATIONOPEN LOOPENGINE WARM UP
1995 Chrysler New Yorker V6-3.5L VIN F
Engine Warm Up
1995 Chrysler New Yorker V6-3.5L VIN FSECTION Engine Warm Up
This is an OPEN LOOP mode.
During engine warm-up, the PCM receives input from:
- Battery voltage
- Crankshaft position (CKP) sensor
- Engine coolant temperature (ECT) sensor
- Intake air temperature (IAT) sensor
- Manifold absolute pressure (MAP) sensor
- Throttle position sensor (TPS)
- Camshaft position (CMP) sensor
- A/C select switch
Based on these inputs the PCM will:
- Apply voltage to the injectors. The PCM then controls injection sequence and pulse width by switching individual injector ground paths on and off.
- Adjust engine idle speed through the IAC motor.
- Adjust ignition timing.
- Begin to monitor oxygen sensor. When engine is at operating temperature, the system will leave warm up mode and go into closed loop operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.