Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1995NEW YORKER V6-3.5L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHSERVICE AND REPAIRTRANSMISSION RANGE SENSOR
1995 Chrysler New Yorker V6-3.5L VIN F
Transmission Range Sensor
1995 Chrysler New Yorker V6-3.5L VIN FSECTION Transmission Range Sensor
REMOVAL
1. Disconnect the TRS connector.
2. Remove valve body assembly from vehicle.
3. Remove manual shaft retaining screw.
4. Slide TRS off of manual valve shaft.
INSTALLATION
To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.