Signal Ground

1995 Chrysler New Yorker V6-3.5L VIN FSECTION Signal Ground
Circuit Z11 connects to cavity 5 of the Powertrain Control Module (PCM)connector. The Z11 circuit provides ground for the sensors that provide inputs to the PCM.

Circuit Z11, which supplies a ground for the PCM sensors, has the same termination point as the Z12 circuit. This ground terminates at the right headlamp ground located at the right front frame rail.

If the system loses ground for the ganged circuits the vehicle will not operate. Check the connection at the ground eyelet.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.