Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE
System Testing
- Check fan motor operation. See MOTORΒ procedure under COMPONENT TESTING. If motor is okay, turn ignition on and check for voltage at fan relay Gray wire. Radiator fan relay is located in power distribution center (inward of right strut tower). See Fig 1 and Fig 2 . A label identifying components and circuits is located under PDC cover.
- If battery voltage exists at Gray wire, go to next step. If battery voltage does not exist, check for open or short circuit in Gray wire circuit. Install jumper wire between Gray and Light Green wires of radiator fan relay. If fan operates, go to next step. If fan fails to operate, check for open or short circuit in Light Green wire between radiator fan relay and fan motor connector.
- If fan operates, warm engine to normal operating temperature. Check for loose connections on fan motor and at fan motor relay. If all connections are okay, check for fault codes.
- Fault codes can be checked by using diagnostic connector, located near battery. Refer to appropriate G - TESTS W/ CODES article in ENGINE PERFORMANCE for complete instructions on connecting diagnostic tester and checking for fault codes. After checking fault codes, see COMPONENT TESTINGΒ . Repair as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
