Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE
Component Testing: Motor
- Locate and disconnect electric fan motor connector at motor. Connect jumper wire from positive terminal of battery to positive terminal of fan connector.
- Connect another jumper wire from negative battery terminal to negative terminal of fan connector. See WIRING DIAGRAMSΒ
. Replace fan motor if fan motor does not run. If fan motor runs, check fan relay, coolant temperature sensor and Powertrain Control Module (PCM).CAUTION: Check electric fan motor operation before checking fan relay and PCM. Ensure PCM is securely grounded.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
