1995 Chrysler LHSFACTORY OEM SERVICE PROCEDURE

Test 84B - Incorrect Ambient Temperature Reading

NOTE: Perform TEST 84A  before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  . Drive vehicle to update OTIS and perform TEST VER-1 - VERIFICATION PROCEDURE  after each repair.
  1. Disconnect Body Control Module (BCM) Bone and Gray connectors. BCM is located behind right kick panel. Using scan tester in ohmmeter mode, measure resistance at terminal No. 15 (Gray/Tan wire) on BCM Bone connector. If resistance is less than 500 k/ohms, repair Gray/Tan wire for partial short to ground. If resistance is 500 k/ohms or greater, go to next step.
  2. Using scan tester in ohmmeter mode, measure resistance at terminal No. 10 (Violet/Light Green wire) on BCM Gray connector. If resistance is less than 500 k/ohms, repair Violet/Light Green wire for partial short to ground. If resistance is 500 k/ohms or greater, go to next step.
  3. Using external ohmmeter, measure resistance between terminal No. 15 (Gray/Tan wire) on BCM Bone connector and terminal No. 10 (Violet/Light Green wire) on BCM Gray connector. If resistance is less than 500 k/ohms, repair Violet/Light Green wire for short to Gray/Tan wire. If resistance is 500 k/ohms or greater, replace BCM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.