Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Fuel Tank: Installation
To install fuel tank, reverse removal procedure. Fill fuel tank. Turn ignition switch to ON position to pressurize fuel system. Check fuel system for leaks.
- Position fuel tank on transmission jack with heat shield and strap in place. Raise and position fuel tank over crossmember. Push filler vent and fill tube over crossmember. Rotate sway bar into position, and remove sway bar brackets.
- Raise fuel tank into place. To complete installation, reverse removal procedure. Use NEW sway bar bracket bolts. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Lower vehicle. Fill fuel tank. Turn ignition switch to ON position to pressurize fuel system. Check fuel system for leaks. Check and adjust rear end alignment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.