Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump: Installation
Clean fuel pump mating surfaces. Install new "O" ring and inlet fuel filter on pump. Install fuel pump and locking ring. Using a hammer and brass drift punch, drive lock ring around clockwise to lock pump in place. To complete installation, reverse removal procedure. Fill fuel tank. Turn ignition switch to ON position to pressurize fuel system. Check fuel system for leaks.
- Clean fuel pump mating surfaces. Install a NEW fuel pump gasket. Insert fuel pump into fuel tank. Ensure 2 fuel tank molded marks and fuel pump triangular mark are aligned. Seat fuel pump by pressing down on top of pump. Ensure gasket does not slip off-center. While holding fuel pump in seated position, place band clamp over lip of tank and edge of pump. Tighten band clamp to specification. See TORQUE SPECIFICATIONSΒ .
- Install pressure relief/rollover valve hose. Connect fuel hoses to fuel tank. Connect wiring harness connectors. Turn ignition switch to ON position to pressurize fuel system. Check fuel system for leaks. To complete installation, reverse removal procedure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
