SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATS - POWER ("A" BODY)TESTINGMOTOR TESTSFRONT MOTOR
1993 Chrysler LeBaron Landau

Front Motor

1993 Chrysler LeBaron LandauSECTION Front Motor
  1. To check front motor, connect jumper wires between Black/Red and Red/Green wires and between Black and Yellow/Green wires.
  2. If motor does not work, reverse jumper leads. Connect jumpers between Black/Red and Yellow/Green wires and between Black and Red/Green wires.
  3. If motor still does not work, check wiring between switch connector and motor. If wiring is okay, replace motor. Rear Motor - 1) To check rear motor, connect jumper wires between Black/Red and Red/Blue wires and between Black and Yellow/Blue wires.
  4. If motor does not work, reverse jumper leads. Connect jumpers between Black/Red and Yellow/Blue wires and between Black and Red/Blue wires.
  5. If motor still does not work, check wiring between switch connector and motor. If wiring is okay, replace motor. If motors and seat operate properly, proceed to SWITCH TEST  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.