Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER WINDOWSREMOVAL & INSTALLATIONFRONT & REAR MOTORS (FLEX DRIVE REGULATORS)INSTALLATION
1993 Chrysler LeBaron Landau
Front & Rear Motors (Flex Drive Regulators): Installation
1993 Chrysler LeBaron LandauSECTION Installation
- Install motor on "T" track. Tighten 2 "T" track-to-motor gearbox screws to 40 INCH lbs. (5 N.m). Insert top of "T" track into access hole. "T" track must point toward hinge pillar.
- Move "T" track until regulator motor is approximately horizontal. Rotate regulator in opposite direction approximately 1/4 turn and align bracket tab to inner panel slot.
- Fasten regulator with proper rivet sequence. See Figure . Operate motor until flex rack is visible within access slot. Attach window and drive arm assembly to flex rack with screw. Tighten screw to 40 INCH lbs. (5 N.m).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.