Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1987FIFTH AVENUE 5.2 4REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICAL5.2L V8 - VINS [P,S,4,8]OVERHAULTIMING CHAININSTALLATION
1987 Chrysler Fifth Avenue 5.2 4
Timing Chain: Installation
1987 Chrysler Fifth Avenue 5.2 4SECTION Installation
- Place camshaft and crankshaft sprockets on bench with timing marks on imaginary centerline through bore of both sprockets. Place timing chain around both sprockets.
- Turn crankshaft and camshaft to line up with keyway location in crankshaft sprocket and camshaft sprocket. Slide both sprockets evenly over their respective shafts, with new chain installed on sprockets.
- Use a straightedge to measure alignment of timing marks. Install fuel pump eccentric, washer and camshaft sprocket bolt and tighten.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.