Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1987FIFTH AVENUE 5.2 4REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER WINDOWSTESTINGWINDOW CONTROL SWITCH TEST
1987 Chrysler Fifth Avenue 5.2 4
Window Control Switch Test
1987 Chrysler Fifth Avenue 5.2 4SECTION Window Control Switch Test
- If failure is in passenger or rear doors, connect jumper wires to that switch connector as shown. See Fig 1 through Fig 5 . Check operation of motor by making jumper connections on left front main switch connector.
- If the failure is in the left front door, it is not necessary to disconnect or jump any other switch. If the motor operates using jumper wires, a switch is the cause of the failure. If window motor does not operate using jumper wires, perform MOTOR LIFT TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.