Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1987CONQUEST 2.6 H, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMFUEL INJECTION SYSTEM - ECIDESCRIPTION & OPERATIONDETONATION SENSOR
1987 Chrysler Conquest 2.6 H, Standard
Detonation Sensor
1987 Chrysler Conquest 2.6 H, StandardSECTION Detonation Sensor
Detonation sensor is installed on cylinder block. It converts vibration into voltage which is sent to ignitor. Ignitor then retards ignition timing to prevent detonation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.