Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- Disable the SIR system. SIR Disabling and Enabling
Pull down the windshield garnish molding (1) rearwards to release the retaining clips (2) and the tether from the A pillar.
- Access the windshield garnish molding bolt (3) on the backside of the windshield garnish molding (1).
- Windshield Garnish Molding Bolt (3) - Remove
Windshield Garnish Molding - Left Side (1) - Remove
Reposition the weatherstrip as necessary.
- Windshield Pillar Assist Handle Cover (1) - Remove [2x]
- Windshield Pillar Assist Handle Bolt (2) - Remove [2x]
- Windshield Garnish Molding - Right Side (3) - Remove
Using a flat bladed plastic trim tool, release the retaining clips.
- {If equipped} Disconnect the electrical connector.
- Instrument Panel Extension (1) - Remove
Radio Front Speaker Bolt (1) - Remove [2x]
- Radio Front Speaker (2) - Remove
- Disconnect the electrical connector.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.