Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2024CORVETTE E-RAY, 2D COUPEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (PROGRAMMING AND SETUP (STINGRAY & Z06))REPAIR INSTRUCTIONSK71 TRANSMISSION CONTROL MODULE: PROGRAMMING AND SETUP (TR-9080 (M1L))REPROGRAM CONTROL MODULE (ECU)
2024 Chevrolet Corvette E-Ray, 2D Coupe
Reprogram Control Module (ECU)
2024 Chevrolet Corvette E-Ray, 2D CoupeSECTION Reprogram Control Module (ECU)
WARNING: This page is about a different variant/trim than selected.
To program an existing K71 Transmission Control Module, perform the following procedure:
- Ignition/Vehicle - Off
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen select K71 Transmission Control Module - Programming, and follow the on screen instructions.
NOTE:
Begin with the vehicle in vehicle OFF power mode. The Service Programming System will power mode the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.