Fastener Specifications

2024 Chevrolet Corvette E-Ray, 2D CoupeSECTION Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β 

Application Specification
Metric (English)
Instrument Panel Airbag
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Air Distributor Case Bolt 12 N.m (106 lb in)
Body Wiring Harness Fuse Block Bracket Bolt 12 N.m (106 lb in)
Brake and Accelerator and Clutch Pedal Bracket Bolt 9 N.m (80 lb in)
Data Link Connector Bolt 2.5 N.m (22 lb in)
Front Floor Console Applique Bolt 7 N.m (62 lb in)
Front Floor Console Armrest Bolt 0.5 N.m (4 lb in)
Front Floor Console Armrest Bolt @ Front Floor Console Armrest Latch 1.5 N.m (13 lb in)
Front Floor Console Armrest Latch Bolt 2.5 N.m (22 lb in)
Front Floor Console Auxiliary Armrest Bolt 2.5 N.m (22 lb in)
Front Floor Console Compartment Bolt 7 N.m (62 lb in)
Front Floor Console Cup Holder Bolt 2.5 N.m (22 lb in)
Front Floor Console Extension Panel Bolt 7 N.m (62 lb in)
Front Floor Console Trim Plate Bolt 2.5 N.m (22 lb in)
Heater and Air Conditioning Evaporator and Blower Module Bolt 7 N.m (62 lb in)
Heater and Air Conditioning Evaporator and Blower Module Nut 7 N.m (62 lb in)
Heater and Blower Module Nut 9 N.m (80 lb in)
Instrument Panel Accessory Bezel Bolt 2.5 N.m (22 lb in)
Instrument Panel Airbag Bolt 9 N.m (80 lb in)
Instrument Panel Carrier Bolt 2.5 N.m (22 lb in)
Instrument Panel Center Lower Bracket Bolt 22 N.m (16 lb ft)
Instrument Panel Cluster Lower Trim Plate Bolt 2.5 N.m (22 lb in)
Instrument Panel Cluster Trim Plate Bolt 2.5 N.m (22 lb in)
Instrument Panel Compartment Bolt 2.5 N.m (22 lb in)
Instrument Panel Extension Bolt 2.5 N.m (22 lb in)
Instrument Panel Knee Bolster Bolt 2.5 N.m (22 lb in)
Instrument Panel Lower Trim Panel Insulator Bolt 2.5 N.m (22 lb in)
Instrument Panel Tie Bar Bolt 22 N.m (16 lb ft)
Instrument Panel Trim Pad Bolt 2.5 N.m (22 lb in)
Instrument Panel Upper Bolt 2.5 N.m (22 lb in)
Instrument Panel Upper Trim Panel Bolt 2.5 N.m (22 lb in)
Radio Bracket Bolt 2.5 N.m (22 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.