Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2024CORVETTE E-RAY, 2D COUPEREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONSUSPENSION CONTROL SYSTEMSSUSPENSION CONTROLS SYSTEM (E-RAY)REPAIR INSTRUCTIONSSUSPENSION CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2024 Chevrolet Corvette E-Ray, 2D Coupe
Removal Procedure
2024 Chevrolet Corvette E-Ray, 2D CoupeSECTION Removal Procedure
- Vehicle Performance Data Recorder Bracket - Remove - Vehicle Performance Data Recorder Bracket Replacement
Electrical Connector (1) @ Electronic Suspension Control Module (2) - Disconnect and position aside
Depress the 2 retaining tabs on the electronic suspension control module bracket in the direction as indicated by the arrows.
- Slide the electronic suspension control module (1) out of the electronic suspension control module bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.