SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2024CORVETTE E-RAY, 2D COUPEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS AND FUEL - 6.2L (LT2) - REPAIR INSTRUCTIONS (E-RAY)REPAIR INSTRUCTIONSSPARK PLUG WIRE REPLACEMENT - RIGHT SIDE
2024 Chevrolet Corvette E-Ray, 2D Coupe

Spark Plug Wire Replacement - Right Side

2024 Chevrolet Corvette E-Ray, 2D CoupeSECTION Spark Plug Wire Replacement - Right Side
GM5368984Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Underbody Rear Air Deflector Replacement
1 Spark Plug Wire [4x]
NOTE:
  • Pull only on the spark plug wire boot to remove the wire.
  • To ensure the spark plug wire rubber boots are correctly seated during installation, push the boot onto the ignition coil until two audible clicks are heard, and push the rubber boot onto the spark plug until one audible click is heard.

Procedure

  1. Twist the spark plug wire boot 1/2 turn and remove the spark plug wire.
  2. Inspect the spark plug wire for damage and replace if necessary.
  3. Inspect the inside of the spark plug rubber boot for a thin, even coat of grease. If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease evenly to the inside of the spark plug rubber boot up to a depth of 15 mm from the end of the boot. Adhesives, Fluids, Lubricants, and Sealers
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.