Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2024CAMARO ZL1, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPSUNROOFREPAIR INSTRUCTIONSSUNROOF MODULE ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2024 Chevrolet Camaro ZL1, 2D Coupe, Standard Trans
Installation Procedure
2024 Chevrolet Camaro ZL1, 2D Coupe, Standard TransSECTION Installation Procedure
- Transfer components as necessary.
With the aid of an assistant, position the new sunroof module assembly using the studs to align the bolt holes.
- Sunroof Module Bolt (2) @ roof - Hand tighten [2x]
- Sunroof Module Bolt (1) @ Sunroof Module Assembly - Hand tighten [6x]
- Sunroof Module Bolt (2) @Roof - Install and tighten [2X] 10 N.m (89 lb in)
- Sunroof Module Bolt (1) @Roof - Install and tighten [6X] 10 N.m (89 lb in)
Drain Hose (1) @ Sunroof Module Assembly - Install
- Electrical Connector @ Sunroof Window Motor - Install
- Electrical Harness @ Sunroof Module Assembly - Install
- Sunroof/Sunshade Motor Initialization (New Motor) , or Sunroof/Sunshade Motor Initialization (Existing Motor)
- Headlining Trim Panel - Install - Headlining Trim Panel Replacement
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.