Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2023TRAVERSE RS, 4WDREPAIR AND DIAGNOSISELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATOR AND WIRING HARNESS ROUTING VIEWSCOMPONENT LOCATORINSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSCENTER CONSOLE COMPONENTS
2023 Chevrolet Traverse RS, 4WD
Center Console Components
2023 Chevrolet Traverse RS, 4WDSECTION Center Console Components
| Items |
|---|
| 1. E27 Instrument Panel Compartment Lamp E27 Instrument Panel Compartment Lamp |
| 2. T22 Mobile Device Wireless Charger Module (K4C) T22 Mobile Device Wireless Charger Module |
| 3. S3 Transmission Shift Lever S3 Transmission Shift Lever |
| 4. S126 Drive Mode Select Switch S126 Drive Mode Select Switch |
| 5. A34 HVAC Controls - Auxiliary A34 HVAC Controls - Auxiliary |
| 6. X92C USB Receptacle - Center Console Rear X92C USB Receptacle - Center Console Rear |
| 7. X81 Accessory Power Receptacle - 110V AC (KI6) X81 Accessory Power Receptacle - 110V AC X1 , or X81 Accessory Power Receptacle - 110V AC X2 |
| 8. X81B Accessory Power Receptacle - 220V AC (KI7) X81B Accessory Power Receptacle - 220V AC X1 , or X81B Accessory Power Receptacle - 220V AC X2 |
| 9. B80 Park Brake Switch B80 Park Brake Switch |
| 10. P2 Transmission Shift Lever Position Indicator P2 Transmission Shift Lever Position Indicator |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.