Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reprogram Control Module
To program an existing K9 Body Control Module, perform the following procedure:
- Ignition/Vehicle OFF.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K9 Body Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K9 Body Control Module - Setup and follow the on-screen instructions.
- Check the driver information center display for additional messages regarding further calibration instructions. If there are no additional driver information center instructions present, programming is complete.
- Clear DTCs.
Begin with the vehicle in vehicle OFF power mode. The Service Programming System will power mode the vehicle.
When performing the Tire Pressure Monitor Sensor Learn during K9 Body Control Module setup, the EL-52545 Tire Pressure Monitor Sensor and RF Diagnostic Tool must be used to activate each tire pressure sensor.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.