Unsuccessful Programming Recovery

2023 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN D, 4WDSECTION Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful configuration and setup event, perform the following steps:

  1. Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
  2. Initiate Vehicle Sleep Mode
    • Ignition/Vehicle - Off
    • Close all doors
    • Remove Key
    • Wait for IPC to time out (up to 2 mins)
  3. Ignition ON / Vehicle in Service Mode
  4. Perform the SPS function: Configuration and Setup
    • If the configuration or setup is not successful - Replace the component: K85P Restraints Occupant Classification System Module - Passenger
    • Go to next step: If the programming is successful
  5. All OK
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.