Replace and Program Control Module or Reprogram Control Module

2023 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN D, 4WDSECTION Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

NOTE:

Begin with the vehicle in the vehicle OFF power mode. The Service Programming System will power mode the vehicle.

  1. Ignition/Vehicle OFF
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. In the SPS Supported Controllers screen, select K73 Telematics Communication Interface Control Module Programming and Service Activation and follow the on-screen instructions.
  4. Clear DTCs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.