Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2023SILVERADO 1500 HIGH COUNTRY, 5.3L ENG VIN D, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATOR AND WIRING HARNESS ROUTING VIEWSCOMPONENT LOCATORINSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSSTEERING COLUMN COMPONENTS
2023 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN D, 4WD
Steering Column Components
2023 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN D, 4WDSECTION Steering Column Components
| Items |
|---|
| 1. K60 Column Lock Module (BTM) K60 Column Lock Module (N06) |
| 2. S78 Turn Signal Switch S78 Turn Signal Switch |
| 3. S3C Automatic Transmission Control Lever (MHT/MQB/MQE) S3C Automatic Transmission Control Lever |
| 4. X85 Steering Wheel Airbag Coil X85 Steering Wheel Airbag Coil X1 (- UKL) , or X85 Steering Wheel Airbag Coil X1 (UKL) , or X85 Steering Wheel Airbag Coil X2 (N57 - D07) , or X85 Steering Wheel Airbag Coil X2 (NK5 / D07) |
| 5. M68 Steering Column Tilt Wheel Actuator (N38) M68 Steering Column Tilt Wheel Actuator (N38) |
| 6. K99 Steering Column Control Module (N38) K99 Steering Column Control Module X1 (N38) , or K99 Steering Column Control Module X2 (N38) |
| 7. M65 Steering Column Telescope Actuator (N38) M65 Steering Column Telescope Actuator (N38) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.