Installation Procedure

2023 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN D, 4WDSECTION Installation Procedure
  1. GM5161801Courtesy of GENERAL MOTORS COMPANY

    Parking Assist Control Module (2) - Install

  2. CAUTION:

    Refer to Fastener Caution .

  3. Parking Assist Control Module Nut (1) - Install and tighten [2x] - Fastener SpecificationsΒ 
  4. Connect the electrical connectors.
  5. GM5786909Courtesy of GENERAL MOTORS COMPANY

    Body Rear Panel Insulator (1) - Install

  6. Return the seat to its original position.
  7. Perform the necessary programming and setup procedure: Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.