Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Using a suitable plastic trim tool, release the retaining tabs.
- Front Floor Console Cup Holder Opening Trim Plate (1) - Remove
- Front Floor Console Rear Cup Holder Liner (2) - Remove
- Front Floor Console Cup Holder Bolt (3) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Rear Cup Holder (1) - Remove
Front Floor Console Rear Cover Bolt (1) - Remove
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Reposition the component to access the electrical connectors.
- Disconnect the electrical connectors and release the wiring harness retainers as necessary.
- Front Floor Console Rear Trim Panel (2) - Remove
Active Safety Control Module Bracket Bolt (1) - Remove [4x]
- Active Safety Control Module Bracket (2) - Remove
Release the retaining tabs.
- Image Processing Module (1) - Remove
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.