Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Image Processing Module (1) - Install
- Secure the retaining tabs.
Active Safety Control Module Bracket (2) - Install
- Active Safety Control Module Bracket Bolt (1) - Install and tighten [4x] - Fastener Specifications
Connect the electrical connectors and install the wiring harness retainers as necessary.
- Front Floor Console Rear Trim Panel (2) - Install
- Front Floor Console Rear Cover Bolt (1) - Install and tighten - Fastener Specifications
Front Floor Console Rear Cup Holder (1) - Install
Front Floor Console Cup Holder Bolt (3) - Install and tighten - Fastener Specifications
- Front Floor Console Rear Cup Holder Liner (2) - Install
- Front Floor Console Cup Holder Opening Trim Plate (1) - Install
- Perform the necessary programming and setup procedure:Control Module References
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.