Theft Deterrent Module Replacement

2023 Chevrolet Malibu LTSECTION Theft Deterrent Module Replacement
GM4213593Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Front Floor Console Rear Air Duct Replacement (Accessory AC and DC Power Control Module Cooler Duct) , or Front Floor Console Rear Air Duct Replacement (With KI6 To Outlet) , or Front Floor Console Rear Air Duct Replacement (Without KI6 To Outlet)
1 Theft Deterrent Module Bolt [2x]
CAUTION:

Refer to Fastener Caution .


Tighten 
1 N.m (9 lb in)
2 Theft Deterrent Module

Procedure

  1. Disconnect the electrical connector.
  2. Disengage tabs on coil and slide rearward to remove.
  3. Control Module References for programming and setup information, if required.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.