Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2023CAMARO SS, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCOMPONENT CONNECTOR END VIEWS (A10-B14C)COMPONENT CONNECTOR END VIEWSA24D DOOR HANDLE ASSEMBLY - DRIVER EXTERIOR
2023 Chevrolet Camaro SS, 2D Coupe, Standard Trans
A24D Door Handle Assembly - Driver Exterior
2023 Chevrolet Camaro SS, 2D Coupe, Standard TransSECTION A24D Door Handle Assembly - Driver Exterior
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool |
|---|---|---|---|
| I | Not required | J-35616-13 (BU) | No Tool Required |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 0.5 0.5 |
GN/WH GN/WH |
3570 3570 |
Driver Door Handle Switch Signal Driver Door Handle Switch Signal |
I I |
(-CM8) CM8 |
| 2 | 0.5 0.5 |
VT VT |
3560 3560 |
Driver Door Passive Entry Antenna High Signal Driver Door Passive Entry Antenna High Signal |
I I |
(-CM8) CM8 |
| 3 | - | - | - | Not Occupied | - | - |
| 4 | 0.5 0.5 |
VT/GY VT/GY |
3561 3561 |
Driver Door Passive Entry Antenna Low Signal Driver Door Passive Entry Antenna Low Signal |
I I |
(-CM8) CM8 |
| 5 | 0.5 | BK | 2150 | Ground | I | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.