SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2023CAMARO SS, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSPOWER SEATSDIAGNOSTIC INFORMATION AND PROCEDURESMEMORY SEAT FEATURE MALFUNCTIONCOMPONENT TESTING
2023 Chevrolet Camaro SS, 2D Coupe, Standard Trans

Component Testing

2023 Chevrolet Camaro SS, 2D Coupe, Standard TransSECTION Component Testing

Driver Seat Memory Switch

  1. Ignition OFF, disconnect the harness connector at the S47D Seat Memory Switch - Driver.
  2. Test for infinite resistance between each signal terminal listed below and the low reference terminal 1 with the switch in the open position.
    • Terminal 5
    • Terminal 6
    • If less than infinite resistance 

      Replace the S47D Seat Memory Switch - Driver.

    • Go to next step: If infinite resistance 
  3. Test for less than 4 Ω between the signal terminal 5 and the low reference terminal 1 while pressing the memory SET button.
    • If 4 Ω or greater 

      Replace the S47D Seat Memory Switch - Driver.

    • Go to next step: If less than 4 Ω 
  4. Test for 573 - 701 Ω between the signal terminal 6 and the low reference terminal 1 while pressing the memory 1 button.
    • If not between 573 - 701 Ω 

      Replace the S47D Seat Memory Switch - Driver.

    • Go to next step: If between 573 - 701 Ω 
  5. Test for 1800 - 2201 Ω between the signal terminal 6 and the low reference terminal 1 while pressing the memory 2 button.
    • If not between 1800 - 2201 Ω 

      Replace the S47D Seat Memory Switch - Driver.

    • Go to next step: If between 1800 - 2201 Ω 
  6. Test for 5.52k - 6.73 kΩ between the signal terminal 6 and the low reference terminal 1 while pressing the Exit button.
    • If not between 5.52k - 6.73 kΩ 

      Replace the S47D Seat Memory Switch - Driver.

    • Go to next step: If between 5.52k - 6.73 kΩ 
  7. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.