Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Windshield Garnish Molding-Right Side (1) - Remove - Windshield Garnish Molding Replacement - Right Side (Coupe) , or Windshield Garnish Molding Replacement - Right Side (Convertible)
Instrument Panel Bolt (1) - Remove
- Disconnect the electrical connectors on the A-pillar.
Starting on the right, pull up on the extension (1) and work your way to the left while releasing the retainer clips.
- Using a flat bladed plastic trim tool, release the retainer clips.
- Disconnect the electrical connector.
Push down on the upper trim panel cover to aid in the release of the front locating instrument panel extension tabs (1).
Instrument Panel Extension (1) - Remove
- Transfer components as necessary.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.