Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2023CAMARO SS, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSTHEFT DETERRENT SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESCONTENT THEFT DETERRENT MALFUNCTION (WITHOUT UTP)CIRCUIT/SYSTEM VERIFICATION
2023 Chevrolet Camaro SS, 2D Convertible, Standard Trans
Circuit/System Verification
2023 Chevrolet Camaro SS, 2D Convertible, Standard TransSECTION Circuit/System Verification
- Ignition ON.
- Verify each indicator/message transitions between the ajar and closed state while opening and closing each vehicle door, hood, and rear compartment.
- If any indicator/message does not change
Refer to Hood Ajar Indicator/Message Malfunction , Door Ajar Indicator Malfunction , or Trunk Ajar Indicator Malfunction .
- Go to next step: If each indicator/message changes
- If any indicator/message does not change
- Completely lower the driver door window and close all vehicle doors, ignition OFF.
- Arm the content theft deterrent system by locking the doors with the keyless entry transmitter.
- Verify the scan tool Content Theft Deterrent Alarm Status parameter is Armed.
- If not Armed
Refer to Keyless Entry System Malfunction .
- Go to next step: If Armed
- If not Armed
- Without disarming the system, reach in through the open driver window and open the driver door.
- Verify the scan tool Content Theft Deterrent Alarm Status parameter is Alarm.
- If not Alarm
Replace the K9 Body Control Module.
- Go to next step: If Alarm
- If not Alarm
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.