SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2023CAMARO SS, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER DOOR LOCKS AND VEHICLE ACCESS SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC P257D-P257FCOMPONENT TESTING
2023 Chevrolet Camaro SS, 2D Convertible, Standard Trans

Component Testing

2023 Chevrolet Camaro SS, 2D Convertible, Standard TransSECTION Component Testing

Static Test

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: B55 Hood Ajar Switch
  3. Test for 658 to 806 ohms between the test points: Signal terminal 1 & Ground terminal 3 - The switch is in the closed position.
    • If not between 658 and 806 ohms 

      Replace the component: B55 Hood Ajar Switch

    • Go to next step: If between 658 and 806 ohms 
  4. Test for 2080 to 2545 ohms between the test points: Signal terminal 1 & Ground terminal 3 - The switch is in the open position.
    • If not between 2080 and 3545 ohms 

      Replace the component: B55 Hood Ajar Switch

    • Go to next step: If between 2080 and 3545 ohms 
  5. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.