Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2022TRAX LT, AWDREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL RESTRAINTS SYSTEMSPECIFICATIONSFASTENER SPECIFICATIONS
2022 Chevrolet Trax LT, AWD
Fastener Specifications
2022 Chevrolet Trax LT, AWDSECTION Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Driver or Passenger Seat Belt Tensioner Cover Fastener | 5 N.m (44 lb in) |
| Driver or Passenger Seat Belt Tensioner Fastener | 45 N.m (33 lb ft) |
| Front Seat Belt Retractor Lower Fastener | 45 N.m (33 lb ft) |
| Front Seat Belt Retractor Upper Fastener | 45 N.m (33 lb ft) |
| Inflatable Restraint Front End Discriminating Sensor | 7.5 N.m (66 lb in) |
| Inflatable Restraint Instrument Panel Lower Module Nut | 9 N.m (80 lb in) |
| Inflatable Restraint Remote Impact Sensor Assembly | 7.5 N.m (66 lb in) |
| Inflatable Restraint Sensing and Diagnostic Module Fastener | 10 N.m (89 lb in) |
| Inflatable Restraint Side Impact Sensor | 7.5 N.m (66 lb in) |
| Instrument Cluster Display Switch Fastener | 1.2 N.m (11 lb in) |
| Instrument Panel Bolt | 2.5 N.m (22 lb in) |
| Instrument Panel Lower Airbag Bracket Bolt | 9 N.m (80 lb in) |
| Rear Seat Bolster Airbag Bracket Bolt | 3.5 N.m (31 lb in) |
| Rear Seat Bolster Airbag Nut | 3.5 N.m (31 lb in) |
| Roof Side Rail Inflatable Restraint Module Fastener | 9.5 N.m (84 lb in) |
| Seat Side Inflatable Restraint Module Nut | 3.5 N.m (31 lb in) |
| Steering Wheel Airbag Coil Bolt | 3 N.m (27 lb in) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.