Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- Disable the SIR system. SIR Disabling and Enabling
Windshield Garnish Molding (1) - Remove - Windshield Garnish Molding Replacement (Chevrolet)
Front Floor Console (1) - Remove - Front Floor Console Replacement (Chevrolet)
Heater and Air Conditioning Control with Cable Control (2) - Remove - Heater and Air Conditioning Control with Cable Control Replacement (C60)
Instrument Panel Outer Trim Cover (1) - Remove - Instrument Panel Outer Trim Cover Replacement (Chevrolet)
Instrument Panel Compartment (2) - Remove - Instrument Panel Compartment Replacement
Instrument Panel Outer Air Outlet - Left Side (1) - Remove - Instrument Panel Outer Air Outlet Replacement - Left Side (Chevrolet)
Instrument Panel Center Air Outlet - Left Side (2) - Remove - Instrument Panel Center Air Outlet Replacement - Left Side (Chevrolet)
Instrument Panel Center Air Outlet - Right Side (2) - Remove - Instrument Panel Center Air Outlet Replacement - Right Side (Chevrolet)
Instrument Panel Outer Air Outlet - Right Side (2) - Remove - Instrument Panel Outer Air Outlet Replacement - Right Side (Chevrolet)
Instrument Cluster (2) - Remove - Instrument Cluster Replacement (Chevrolet)
Headlamp Switch (1) - Remove - Headlamp Switch Replacement
Daytime Running Lamp Ambient Light Bezel (1) - Remove - Daytime Running Lamp Ambient Light Bezel Replacement (Chevrolet)
Forward Collision Alert Display Bezel (1) - Remove - Forward Collision Alert Display Bezel Replacement (With UEU, Chevrolet) , or Forward Collision Alert Display Bezel Replacement (Without UEU, Chevrolet)
Instrument Panel Bolt (1) - Remove [11x]
Instrument Panel Airbag Bolt (1) - Remove [2x]
- Instrument Panel Compartment Door Latch Striker Bolt (2) - Remove
- Disconnect the instrument panel airbag electrical connector from the instrument panel harness.
- Note the location and routing of the instrument panel electrical harness assembly, to ensure proper reinstallation.
- Disconnect the fasteners securing the instrument panel electrical harness assembly to the instrument panel and position out of the way.
With the aid of an assistant, lift the instrument panel (1) rearward and upward from the tie bar assembly.
- Remove the instrument panel (1) from the vehicle.
- Transfer components as necessary.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.