Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
With the aid of an assistant, load the instrument panel (1) to the instrument panel tie bar to the locator pins.
- Reposition the instrument panel wiring harness into the vehicle position as was noted in the removal and connect the fasteners securing the instrument panel wiring harness to the instrument panel (1).
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Bolt (1) - Install and tighten [11x] 2.5 N.m (22 lb in)
Instrument Panel Airbag Bolt (1) - Install and tighten [2x] 9 N.m (80 lb in)
- Instrument Panel Compartment Door Latch Striker Bolt (2) - Install and tighten 9 N.m (80 lb in)
- Connect the electrical connector.
Forward Collision Alert Display Bezel (1) - Install - Forward Collision Alert Display Bezel Replacement (With UEU, Chevrolet) , or Forward Collision Alert Display Bezel Replacement (Without UEU, Chevrolet)
Daytime Running Lamp Ambient Light Bezel (1) - Install - Daytime Running Lamp Ambient Light Bezel Replacement (Chevrolet)
Headlamp Switch (1) - Install - Headlamp Switch Replacement
Instrument Cluster (2) - Install - Instrument Cluster Replacement (Chevrolet)
Instrument Panel Outer Air Outlet - Right Side (2) - Install - Instrument Panel Outer Air Outlet Replacement - Right Side (Chevrolet)
Instrument Panel Center Air Outlet - Right Side (2) - Install - Instrument Panel Center Air Outlet Replacement - Right Side (Chevrolet)
Instrument Panel Center Air Outlet - Left Side (2) - Install - Instrument Panel Center Air Outlet Replacement - Left Side (Chevrolet)
Instrument Panel Outer Air Outlet - Left Side (1) - Install - Instrument Panel Outer Air Outlet Replacement - Left Side (Chevrolet)
Instrument Panel Compartment (2) - Install - Instrument Panel Compartment Replacement
Instrument Panel Outer Trim Cover (1) - Install - Instrument Panel Outer Trim Cover Replacement (Chevrolet)
Heater and Air Conditioning Control with Cable Control (2) - Install - Heater and Air Conditioning Control with Cable Control Replacement (C60)
Front Floor Console (1) - Install - Front Floor Console Replacement (Chevrolet)
Windshield Garnish Molding (1) - Install - Windshield Garnish Molding Replacement (Chevrolet)
- Enable the SIR System. SIR Disabling and Enabling
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.