Outside Rearview Mirror Glass Replacement

2022 Chevrolet Trax LT, AWDSECTION Outside Rearview Mirror Glass Replacement
GM2780047Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Outside Rearview Mirror Glass Retainers (Qty: 9)
WARNING:

Approved safety glasses and gloves should be worn when performing this procedure to reduce the chance of personal injury.

Procedure

  1. Place masking tape over the mirror glass and around the mirror housing.
  2. Carefully push the outside rearview mirror glass upward and into the right corner of the mirror housing, allowing access to the bottom edge.
  3. Grasp the bottom edge of the mirror glass firmly, lift upward and pull rearward until the mirror glass releases the motor ring.
  4. Disconnected the connectors from the back of the mirror glass.
2 Outside Rearview Mirror Glass

Procedure

  1. Place the mirror glass on the lower motor ring retainers.
  2. Place one hand on the back of the mirror housing, using the flat palm of the other hand press inward locking the mirror glass to the motor ring.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.