SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2022TRAX LT, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD OUTSIDE MOISTURE SENSOR REPLACEMENT
2022 Chevrolet Trax LT, AWD

Windshield Outside Moisture Sensor Replacement

2022 Chevrolet Trax LT, AWDSECTION Windshield Outside Moisture Sensor Replacement
GM2844487Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the outside moisture sensor cover. Refer to Windshield Outside Moisture Sensor Cover Replacement (Buick) , or Windshield Outside Moisture Sensor Cover Replacement (Chevrolet) .
  2. Disconnect the electrical connector at the top side of the windshield outside moisture sensor.
1 Windshield Outside Moisture Sensor Assembly

Procedure

  1. Pinch the tabs on both outer edges of the windshield outside moisture sensor.
  2. Push the windshield outside moisture sensor upward from the windshield base.
  3. Remove the windshield outside moisture sensor from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.