Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
2022 Chevrolet Trax LT, AWDSECTION Circuit/System Verification
- Ignition ON.
- Verify DTC U151A is not set.
- If DTC is set
Refer to DTC U1500-U15FF .
- Go to next step: If DTC is not set
- If DTC is set
- Place the S82 Windshield Wiper/Washer Switch in the intermittent delay setting and spray the outside of the windshield in the area of the B200 Rain Sensor Module with a water bottle. It may be necessary to increase the sensitivity of the intermittent delay to achieve windshield wiper operation.
- Verify the windshield wipers operate at low speed.
- If the wipers are not operating at low speed
Refer to Circuit/System Testing.
- Go to next step: If the wipers are operating at low speed
- If the wipers are not operating at low speed
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.