Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
- Ignition - On/Vehicle - In Service Mode
- Verify the scan tool parameter: Lane Departure Warning Switch Status = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component: Lane Departure Warning Switch - Press and hold the switch
Verify the scan tool parameter: Lane Departure Warning Switch Status = Active
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Cycle the component from the open position to the closed position: Lane Departure Warning Switch
Verify the component turns On and Off: Lane Departure Warning Switch Indicator
- If the component does not turn On and Off
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the component turns On and Off
- If the component does not turn On and Off
- Refer to: Scan Tool Information - Frontview Camera Disable History 1-4
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.