Circuit/System Verification

2022 Chevrolet Trax LT, AWDSECTION Circuit/System Verification
  1. Ignition ON/vehicle in Service Mode, radio ON.
  2. Verify that audio is heard clearly through all speaker channels when tuning radio to a known good station.
    • Go to next step: If audio is heard clearly 
  3. Verify that the Connecting to OnStar® message is heard clearly through the audio system when the OnStar® blue button is pressed.
    • If OnStar message is noisy or distorted 

      Refer to Circuit/System Testing

    • Go to next step: If OnStar message is heard clearly 
  4. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.