SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2022TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIMREPAIR INSTRUCTIONSROCKER PANEL MOLDING REPLACEMENT
2022 Chevrolet Traverse High Country, FWD

Rocker Panel Molding Replacement

2022 Chevrolet Traverse High Country, FWDSECTION Rocker Panel Molding Replacement
GM4742069Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Rear Tire Front Air Deflector Replacement
  2. Open the front and rear side doors.
1 Front Wheelhouse Liner Bolt [2x]
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
2 Rocker Panel Molding

Procedure

  1. Using the appropriate tool, release the retainers from the bottom edge and pull down the rocker panel molding from the body side outer panel.
  2. Using the appropriate tool, release the retainers from the top edge, pull out the rocker panel molding from the body side outer panel and remove from the vehicle.
  3. Close the front and rear side doors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.