SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2022TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIMREPAIR INSTRUCTIONSFRONT WHEEL OPENING MOLDING REPLACEMENT
2022 Chevrolet Traverse High Country, FWD

Front Wheel Opening Molding Replacement

2022 Chevrolet Traverse High Country, FWDSECTION Front Wheel Opening Molding Replacement
GM4742175Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Front Wheel Opening Molding Retainer [7x]
2 Front Wheel Opening Molding Clip [3x]
3 Front Fender Wheel Opening Molding

Procedure

  1. Apply two layers of masking tape around the top edge of the front wheel opening molding to prevent any paint surface damage.
  2. Using a suitable flat bladed plastic tool, release the retainers from the front fender.
  3. Pull upward to release the molding from the front bumper lower fascia.
  4. Using a 50/50 mixture of isopropyl alcohol and clean drinkable water and a clean towel, remove the left over adhesive residue from the masking tape.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.