Installation Procedure

2022 Chevrolet Equinox LS, FWDSECTION Installation Procedure
  1. Position the transmission control assembly to the transmission control bracket.
  2. GM5862573Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Control (2) - Install

  3. Automatic Transmission Control Nut (1) - Install and tighten [ 3x ] 9 N.m (80 lb in)
  4. Connect the transmission control electrical connector.
  5. Connect the automatic transmission range selector lever cable to the transmission control. Range Selector Lever Cable ReplacementΒ 
  6. Install the front floor console. Front Floor Lower Console Replacement (Equinox)
  7. Release the park brake.
  8. Adjust the automatic transmission range selector lever cable. Range Selector Lever Cable AdjustmentΒ 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.